Table of Contents
Advertisement
Table 4-5 lists the parameters you must select to activate the PPPoE protocol.
Parameter
User Name
Password
Please retype
your password
Service Name
MTU
Maximum Idle Time
Auto-reconnect
Back button
OK button
Table 4-5. PPPoE parameters.
Type in the user name provided by your ISP for the
PPPoE connection.
Type in the password provided by your ISP for the
PPPoE connection.
Type in the password again to reconfirm.
This is optional. Type in the service name if your ISP
requires it; otherwise, leave it blank.
This is optional. Type in the maximum size of your
transmission packet to the Internet. Leave it as is if
you to not wish to set a maximum packet size.
Type in an idle time threshold (minutes) for the WAN
port. This means that if no packets have been sent
(no one using the Internet) during this specified
period, the router will automatically disconnect the
connection with your ISP.
If you check the Auto-reconnect function, then when
the WAN connection is disconnected, the router will
automatically reconnect when a user requests access
to the Internet.
Click on this button to go back to the previous screen.
Click on this button to save your changes and go on
to the next screen.
CHAPTER 4: Quick Setup Wizard
Description
33
Advertisement
Table of Contents
