Table of Contents
Advertisement
Once you've configured your PC to obtain an IP address automatically, proceed to
step 3 (below).
3. Once you have configured your PCs to obtain an IP address automatically, the
router's DHCP server will automatically give your LAN clients an IP address.
By default, the Pure Networking Broadband Router's DHCP server is enabled
so that you can obtain an IP address automatically. To see if you have
obtained an IP address, see Appendix A.
Make sure that the Pure Networking Broadband Router's DHCP server is
the only DHCP server available on your LAN. If there is another DHCP
on your network, then you'll need to switch one of the DHCP servers off.
4. Once your PC has obtained an IP address from your router, enter the default
IP address 192.168.2.1 (the Pure Networking Broadband Router's IP
address) into your PC's Web browser and press Enter. See Figure 3-6.
5. The screen shown in Figure 3-7 will appear. This site contains the router's
Web-based management screens that allow you to configure your Pure
Networking Broadband Router. Click on LOGIN.
By default there is no password. For security reasons, we recommend
that you add a password as soon as possible (see Figure 3-7).
Figure 3-6. Entering the default IP address.
CHAPTER 3: Getting Started
NOTE
NOTE
21
Advertisement
Table of Contents
