Pppoe; Pptp; Static Ip Address; Bridge - Black Box LR9603A User Manual

PURE NETWORKING BROADBAND ROUTER
5.2.2 PPP E
O
Select PPPoE if your ISP requires the PPPoE protocol for connecting to the
Internet. Your ISP should provide all the information required in this section.

5.2.3 PPTP

Select PPTP if your ISP requires the PPTP protocol for connecting to the Internet.
Your ISP should provide all the information required in this section.
5.2.4 S IP A
TATIC DDRESS
Select Static IP Address if your ISP has given you a specific IP address for you to
use. Your ISP should provide all the information required in this section.
5.2.5 B
RIDGE
The bridge mode screen allows you to set your Pure Networking Broadband
Router to bridge mode and assign an IP address for management purposes. When
the bridge mode is selected, the router in effect becomes a switch, transferring
packets from the WAN port to the LAN port and vice versa without any NAT
involvement. In bridge mode, the original WAN MAC is ignored, and the original
LAN MAC address will be used as the MAC address. These values will be restored
when you set the device to operating modes other than the bridge mode. See
Figure 5-8.
Figure 5-8. Configuring the router as a bridge.
48