Changing The Final Transmission Oil; Adjusting The Drive Chain Slack - E-TON Yukon II Service Manual

CHECKING THE FINAL TRANSMISSION OIL/

ADJUSTING THE DRIVE CHAIN SLACK

1
2

CHANGING THE FINAL TRANSMISSION OIL

1. Place the machine on a level surface.
2. Place a receptacle under the final transmission
case.
3. Remove:
• final transmission oil filler cap
• final transmission oil drain plug
4. Drain:
• final transmission oil
5. Install:
• final transmission oil drain plug
• final transmission oil filler cap
TIP
Check the gasket (drain plug). If it is damaged,
replace it with a new one.
6. Fill:
• final transmission case
Total amount
0.75 L (0.66 Imp qt, 0.79 US qt)
Recommended oil
SAE80W-90 gear oil
N O T I C E
Take care not to allow foreign material to
enter the final gear case.
ADJUSTING THE DRIVE CHAIN SLACK
TIP
• Measure the drive chain slack halfway between
the drive axle and the rear axle.
• When checking and adjusting the drive chain
slack, there should be no weight on the vehicle
and all tires must be touching the ground.
N O T I C E
A drive chain that is too tight will overload
the engine and other vital parts, and one that
is too loose can skip and damage the swin-
garm or cause an accident. Therefore, keep
the drive chain slack within the specified
limits.
3 - 23
CHK
ADJ
1
2
25 Nm (2.5 m kg, 18.1 ft Ib)
• •
25 Nm (2.5 m kg, 18.1 ft Ib)
• •