Changing The Engine Oil - E-TON Yukon II Service Manual

1
1

CHANGING THE ENGINE OIL

CHANGING THE ENGINE OIL
1. Start the engine, warm it up for several min-
utes, and then turn it off.
2. Place a container under the engine oil drain
bolt.
3. Remove:
• dipstick
• engine oil drain bolt
(along with the O-ring, spring and oil filter
2
screen)
4. Drain:
• engine oil
(completely from the crankcase)
5. Check:
• engine oil drain bolt gasket
Damage → Replace.
6. Install:
• engine oil drain bolt
(along with the O-ring, spring and oil filter
screen)
7. Fill:
• crankcase
(with the specified amount of the recom-
mended engine oil)
Quantity
Total amount
Periodic oil change
8. Install:
• dipstick
9. Start the engine, warm it up for several min-
utes, and then turn it off.
10.Check:
• engine
(for engine oil leaks)
11.Check:
• engine oil level
Refer to "CHECKING THE ENGINE OIL
LEVEL".
12.Check:
• oil lubrication by oil check bolt
3 - 16
CHK
ADJ
1
2
1
8 Nm (0.8 m kg, 5.8 ft
•
1.00 L (0.88 Imp qt, 1.06 US qt)
0.90 L (0.79 Imp qt, 0.95 US qt)
Ib)
•