Installing The Rear Brake Master Cylinder; Installing The Front Brake Lever Assembly - E-TON Yukon II Service Manual

2
1
4
1
3
STEERING SYSTEM
INSTALLING THE REAR BRAKE
3
CYLINDER
1. Install:
• handlebar switch
• handlebar grip
• brake master cylinder
TIP
• Installing the rear
sure the handlebar switch
2
positions shown in the illustration.
•
Install the
the
master cylinder holder
The "UP" mark on the brake master cylinder
•
bracket should face up.
5
INSTALLING THE FRONT BRAKE LEVER
ASSEMBLY
1. Install:
• front brake lever assembly
• handlebar grip
TIP
• Install the front brake lever assembly, please
2
align the
front brake lever assembly
• Installing the front brake lever assembly, make
sure the clearance the front brake lever assembly
3
2. Adjust:
• front brake
Refer to " ADJUSTING THE FRONT BRAKE"
4
in chapter 3.
6 - 27
CHAS
brake master
, and brake master cylinder
brake master cylinder, please align
4
punch mark and
5
.
Brake master cylinder bracket
14 Nm (1.4 m•kg, 10.1 ft•lb)
1
punch mark
4
and handlebar grip .
MASTER
cylinder, make
1
, handlebar grip
3
are in the
the gap at brake
and the gap at
2 .