Checking The Rear Brake Fluid Level - E-TON Yukon II Service Manual

CHECKING THE REAR BRAKE FLUID LEVEL

1
CHECKING THE REAR BRAKE FLUID LEVEL
1. Place the machine on a level surface.
TIP
When checking the brake fluid level, make sure
that the top of the brake master cylinder reser-
voir or brake fluid reservoir is horizontal.
2. Check:
• brake fluid level
Below the minimum level mark
the recommended brake fluid to the proper
level.
Recommended brake fluid
DOT #4
WARNING
• Use only the designated brake fluid.
Other brake fluids may cause the rubber
seals to deteriorate, causing leakage and
poor brake performance.
• Refill with the same type of brake fluid that
is already in the system. Mixing brake flu-
ids may result in a harmful chemical reac-
tion, leading to poor brake performance.
• When refilling, be careful that water does
not enter the brake fluid reservoir. Water
will significantly lower the boiling point of
the brake fluid and could cause vapor
lock.
N O T I C E
Brake fluid may damage painted surfaces
and plastic parts. Therefore, always clean
up any spilt brake fluid immediately.
TIP
In order to ensure a correct reading of the
brake fluid level, make sure that the top of the
brake master cylinder reservoir or brake fluid
reservoir is horizontal.
3 - 20
CHK
ADJ
1
→ Add