Checking Transmission Oil Level; Changing Transmission Oil - E-TON CXL-150 Owner's Manual

Yukon ii
Table of Contents

Advertisement

Slowly move the shifting lever to the desired
gear pausing slightly at the neutral position.
Once you have the gear selected increase the
throttle slowly until the transmission becomes
fully engaged and the vehicle starts moving in
the desired direction.
When shifting gears it is important that you
bring the vehicle to a complete stop with the
rear brake fully engaged and the engine at idle.
If you attempt to shift the transmission with the
engine running above the idle speed the
engine will automatically shut down to protect
the transmission.
If this should happen you will need to turn off
the ignition switch to reset the safety lock out
before attempting to restart the engine.
Transmission Oil
Your ATV uses SAE 80/90W gear oil to
lubricate the drive and transmission gears.
There is an oil sight glass in the side of the
transmission case to check the level of the oil
in the gear box. The oil level is correct when
the level in the sight glass is half way up the
glass. The level should be checked with the
engine stopped and cold. Checking the level
when the engine is hot can cause a false
reading and lead to a low gear oil level.
Your gear oil should be checked before each
riding session. The gear oil should be changed
before each riding season or every 1000 hours
operation.
Copyright ©2008-2009 ETON America, all rights reserved.

Changing Transmission Oil

1. Place an oil catch pan under the unit
directly below the transmission box.
2. Remove the transmission box drain
plug located on the bottom of the
transmission box on the underside of
the unit.
3. Remove the transmission box fill hole
plug locate on top of the transmission
box on the right hand side of the engine.
4. Allow the oil to drain completely (15-
30 min).
5. Reinstall the drain plug and tighten.
Torque to 7-10ft-lbs
6. Fill the transmission box with SAE 80-
90 gear oil, 750cc / 25.4oz
7. Reinstall the fill hole plug and torque to
2-3lbf-ft.
Dispose of used oil at a proper
8.
recycling station as required by law.
Page 13

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Yukon ii cxl-150

Table of Contents