Checking The Rear Wheel Hubs; Installing The Wheel Hubs - E-TON Yukon II Service Manual

FRONT AND REAR WHEELS
1
2
New
WARNING
Eye protection is recommended when using
striking tools.
c. To install the wheel bearings, reverse the
above sequence. Use a socket that
matches outside diameter of bearing outer
race to drive in bearing.
N O T I C E
Do not strike the center race or balls of the
bearing. Contact should be made only with
the outer race.

CHECKING THE REAR WHEEL HUBS

The following procedure applies to both of the
rear wheel hubs.
1. Check:
• wheel hub splines
Wear/damage → Replace.

INSTALLING THE WHEEL HUBS

The following procedure applies to both of the
front and rear wheel hubs.
1. Install:
• axle nut 1
Front wheel hub:
80 Nm (8.0 m
Rear wheel hub:
80 Nm (8.0 m
• cotter pin 2
New
TIP
Do not loosen the axle nut after torquing it. If
the axle nut groove is not aligned with the cot-
ter pin hole, align the groove with the hole by
tightening the axle nut.
6 - 4
CHAS
1
kg, 97.6 ft lb)
• •
kg, 97.6 ft lb)
• •