Engine Oil; Tires & Wheels; Tire Inspection; Tire Pressure - E-TON Viper 40E (RXL-40E) Owner's Manual

To replace the filter, first turn the fuel valve to
the "OFF" position. Then carefully compress
the wire clamp rings until the clamp is free of
the fuel line. Slide each clamp away from the
filter about ¾".
Remove the filter from the fuel line by holding
the line and pulling the filter. Install the new
filter by inserting the filter into the fuel line and
returning the clamps to the original position.
Turn the fuel valve to the "ON" position and
check for leaks. Inspect the fuel lines for cuts,
abrasions and deterioration. Replace fuel
lines as needed.
DO NOT start or operate the engine if the fuel
filter or lines are leaking. Leaking fuel can
cause a fire.

Engine Oil

2 Cycle Engine
Your ATV uses 2 cycle oil to lubricate the
engine. The oil is mix with the fuel prior to
refueling the unit. Use a synthetic 2 cycle oil
and mix at a 50:1 ratio with the fuel.
(About 2.5oz to a gallon)
Never run the engine with straight fuel as
sever engine damage will occur requiring
the engine to have to be rebuilt or
replaced.
Tires and Wheels
Tire & Wheel inspection
It is important to inspect your tires and wheels
for damage and wear before each riding
session. Inspect each tire for cuts, tears and
punctures. Inspect the wheel rim for dents
and separation of the wheel from the tire bead.
Replace any tire or wheel found to be
damaged.
Operating your ATV with damaged tires or
wheels is dangerous. Damaged tires or
wheels can result in a sudden loss of tire
pressure and control which could result in
injuries.
Check your tire pressure before each riding
session and at each refueling operation. Always
check the pressure when the tires are cool. Use
the tire pressure gauge that came with your ATV
to check the tire pressure.

Tire Pressure

Recommended tire pressure is:
7psi Maximum (Hot after riding)
2psi Minimum (Cold before riding)
Wheel Nut torque 24-30 N/m (18-22 lb/ft)

Spark Plug

Replace spark plug at the beginning of each
season with a replacement plug
NGK BPM6Y/NGK
Disconnect spark plug wire.
Clean dirt from around spark plug base with
brush or air.
Remove spark plug with spark plug wrench.
Set the spark plug gap on the new plug to 0.023"
Install the new by plug screwing it in finger tight
and then use the plug wrench to screw the plug
in another ½ turn.
Inspect the spark plug wire for cuts, nicks or
other damage. Replace as needed.
Page 10