Engine Oil; Checking Engine Oil Level; Changing Engine Oil - E-TON CXL-150 Owner's Manual

Engine Oil

Your ATV uses automotive type engine oil to
lubricate the engine. The engine oil dip stick is
located on the right hand side of your engine
below the transmission shifting lever.
To check your oil level, remove the dip stick by
turning the thumb hold counter clockwise until
the stick has been completely disengaged from
the threads. Pull the dip stick out of the
crankcase and check the level of the oil as
indicated on the dip stick. The engine oil is full
when the oil reaches the level on the stick as
indicated in the photo above.
Always check your engine oil level with the
engine off and cold. Removing the dip stick
with the engine running could cause hot oil to
splash from the crankcase causing severe
burns.
Checking your engine oil while the engine is
hot can give you a false reading; always check
the oil level with a cold engine.
Your engine requires SAE 30W engine oil and
the crankcase capacity is 1.0 Liters / 1 quart.
The engine oil should be changed before the
start of each riding season or every 300 hours
of operation. When riding where conditions are
Copyright ©2008-2009 ETON America, all rights reserved.
dusty or humidity is high the engine oil should
be change more frequently.

Changing Engine Oil

1. Place an oil catch pan under the unit
directly below the engine crankcase.
2. Remove the crankcase drain plug
located on the bottom of the crankcase
on the underside of the unit.
3. Remove the engine oil dipstick located
on the right hand side of the engine
below the shifter shaft.
4. Allow the oil to drain completely (15-
30 min).
5. Reinstall the drain plug and tighten.
Torque to 7-10ft-lbs
6. Fill the crankcase with of SAE 30W
engine oil through the dip dipstick hole.
1 liter / 1 quart.
7. Reinstall the engine oil dipstick and
finger tighten.
Dispose of used oil at a proper
8.
recycling station as required by law
Page 11