Konica Minolta bizhub 250 Ssd Support Solutions page 63

bizhub 250
When doing a copy job with less then ten prints, there is a shortpause before executing a sent print job.
Solution
CAUSE: This is machine specification which allowsa person copyingat the machine time to start another short copy job without mixing small copy and print
jobs.
SOLUTION: If the user does not want to have the short break between both, a HDD must be installed (HD-504, Item#4599461, 40GB Hard Disk Drive).
SPECIAL NOTE : Solution contribution by KM Europe (BEU).
TAUS0808226EN*
Solution ID
Description
How to adjust the LCD touch panel
Solution
When the Touch Panel is slow to respond when touched proceed through the following steps:
1. Use the warm boot button on the MFBS board, next to right of the CF card slot, Press once and release.
2. The LCD will go blue then to the KM logo, seven seconds the screen will have a white square on left edge of LCD.
3. Press "3" then enter 8 zeros and press "END" on touch screen.
4. Call the Maintenance Mode to the screen.(Trouble Reset)
5. Touch the "Touch Panel Adjustment'.
6.. Following the arrow, sequentially press four points (+) on the screen using a pen or similar object.
7. Press "END" to go to complete, Power Off main power and ON.
NOTE • Press the very center of each point. • Use care not to allow the tip of the pen to damage the surface of the screen.
SPECIAL NOTE: Solution contribution by Don St. Onge, Workgroup/SSD
Solution ID TAUS0808294EN*
Description
How to turn offthe e-mail confirmation page without turning off the fax confirmation page.
Solution
To disable the e-mail confirmation page without disabling the fax confirmation page, perform the following:
1. Enter the service mode.
2. Select soft switch settings.
3.Press Mode Selection and enter 368.
4.Press Bit Selection and use the arrow key to move the cursor tobit1.
5. Press the 0 key(on the 10-key pad) and press set.
6. Exit the service mode.
SPECIAL NOTE: Solution contribution by Bill Hall, Workgroup/SSD
Solution ID TAUS0900083EN*
Description
How to default the opening scan size of a scanned document from Adobe® Acrobat® 7/8/9.
Solution
To default the opening scan size of a scanned document via Adobe® Acrobat® 7/8/9 perform the following:
1.Open a PDF.
2.Select Edit and then Preferences (see attached photo).
3.Click on Page Display => Magnification. Zoom to Scroll and select the desired opening size.
SPECIAL NOTE : Solution contribution by Mark D'Attilio/Ian Lynch/Cesar Jimenez, Production Print/SSD
Copyright 2009, Konica Minolta Business Solutions U.S.A., Inc.
63
Miscellaneous
Solution Usage
Solution Usage
Solution Usage
October 2009