Konica Minolta bizhub 250 Ssd Support Solutions page 128

bizhub 250
3. Press Hard Disk Format. Once format is complete cycle the power of the main body.
Solution ID TAUS0650524EN*
Description
FK503, E5AF4B when attempting to fax out. The machine will receive faxes without a problem.
Solution
CAUSE: Fax soft switch setting conflict.
SOLUTION: To initialize the fax soft switch settings, perform the following:
1. With the copier powered ON, press the reset switch on the RAM board which is located on the right side of the machine. The machine will indicate
PLEASE WAIT, followed by the Konica Minolta initial screen with a dot located on the left side of the touchscreen.
2. Press the [3] key.
3. Enter the Administrator Password (default is 00000000).
4. Touch [END] on the touchscreen.
5. Touch [Clear FAX Settings] on the touchscreen.
6. Touch [Soft Switch] on the touchscreen.
7. Touch [END] on the touchscreen.
8. Touch [YES] on the touchscreen.
9. Touch [ENTER] on the touchscreen.
10. Touch [EXIT] on the touchscreen. The machine will emit an audible beep and power itself OFF.
11. Power the copier ON to complete the reset process.
TAUS0650764EN*
Solution ID
Description
C4101 code at power up.
Solution
PROBABLE CAUSES:
1.Failed PWB-A (Mechanical CB).
Replace the PWB-A board (p/n 4040 0101 03).
2.No 24V DC at PJ17A, pin 5.
Replace the 3.15A fuse located on the power supply.
3. Polygon motor in thePrint Head Assembly fails to turn.
Begin by checking the connections to the Print Head Assembly. Unplug and reseat all connections. If issue continues, replace the Print Head Assembly
(p/n4040-0751-00).
TAUS0651213EN*
Solution ID
Description
DF605, unable to clear the Original Left On Glass message.
Solution
CAUSE: The metrics original size is enabled.
SOLUTION: To disable the metrics original size and calibrate inch size, perform the following:
1. Access the Tech Rep Mode and go to System Input.
2. Select the Original Size Detect Option, then select NO.
3. Go to Function and do a F7-1; the display will look like it is doing nothing, but it is doing a metric size sensor calibration. 4. After 20 - 30 seconds (do not
press END) just power OFF the main switch. This should log the new calibration for Inch paper.
Solution ID TAUS0651759EN*
Description
When restoring saved driver settings using the PCL* driver, the paper size is not retained.
Solution
CAUSE: The Detailed Restore Setting for Paper Size, Orientation, Copies is not enabled.
SOLUTION: Open the driver properties. On the General Tab, click on Printing Preferences. Now click on the Setup Tab, then click on the Save/Restore
Setting button at the right side. From the drop down menu, click on Detailed Restore Setting. The Restore Items are listed. To restore the original size, you
must check the box for Original Size, Orientation, Copies. Default for this box is OFF.
Note: Other settings that are OFF by default include Paper Type Setting and Overlay.
* Trademark ownership information
Copyright 2009, Konica Minolta Business Solutions U.S.A., Inc.
128
Solution Usage 2
2
Solution Usage
2
Solution Usage
Solution Usage 2
October 2009