Installation - IDTECK SRK101 Hardware Manual

6. Installation

6-1. Make sure the magnet is attached to the magnet guide on the Wall Mount.
6-2. On the last page of this manual, you can find an actual-size template for the Wall Mount. Cut
the page out and use it as a guide to help you drill two 6-32 or M3 screw holes and one 1/2"
hole. (If an electric gang box is already installed, skip this procedure.)
6-3. Using two 6-32 or M3 screws, install the Wall Mount to the wall.
※Caution:
Once mounted to Wall Mount, the Main Unit can't be unmounted. Therefore, it is important
to have all functions tested before mounting to the Wall Mount. If you unmount an
already-installed Main Unit from the Wall Mount, the lock parts on the Wall Mount will be
broken, and you'll have to replace it with a new Wall Mount.
6-4. Insert 5 O-rings to the Wall Mount, and route the cable of the Main Unit through the center hole
and push the Main Unit to the Wall Mount until it locks into place.
8
Magnet guide