1. Important Safety Instructions When using NESS - IDTECK SR10/SR20 Philips Mifare™ Compatible Proximity Reader, basic safety precautions should always be followed to reduce the risk of fire, electrical shock, and injury to persons. In addition, the following should also be followed: 1.
The NESS - IDTECK SR10/ SR20 Philips Mifare™ Compatible Proximity Reader is an elegant looking 10cm (4”) read range Proximity Reader that can be mounted to any flat wall surface. The SR10 / SR20 Philips Mifare™ Compatible Reader which reads serial numbers from Philips Mifare™ compatible cards and transmits the data to the control panel in various output formats.
IDTeck – SR10 / 20 SMART CARD PROXIMITY READER 7. Wire Colour Table of the SR10/20 POWER Power (DC +7V ~ +17V) DC (+) Red wire Power (Ground) Black wire INPUT LED Control LED_CON Yellow wire Buzzer Control Buzzer_CON Blue wire...
DATA : 10 characters for 4-byte output, 8 characters for 3-byte. : The value made from XORing every byte from ‘NESS - IDTECK’ through ‘END’ 9. Wire Connection to Controller The brown and the orange wire MUST be left unconnected. The violet wire is reserved for RS-232C output.
IDTeck – SR10 / 20 SMART CARD PROXIMITY READER 11. FCC REGISTRATION INFORMATION FCC REQUIREMENTS PART 15 Caution: Any changes or modifications in construction of this device, which are not expressly approved by the manufacturer for compliance, could void the user's authority to operate the equipment.