Operations - IDTECK SRK101 Hardware Manual

10. Operations

10-1. Connector Layout
JP2, JP4 : OFF (Do not change these jumpers by yourself.)
10-2. Output Selection
Table 1. Jumper Setting (SRK101/SRK101U/SRK101B)
JP3 JP5
OFF OFF
OFF ON
ON OFF
ON ON
※ CAUTION: By default, both JP3 and JP5 are OFF.
10-3. Operations
10-3-1. Basic Operations
1. After powered on, the Reader beeps 4 times and the LEDs are turned on and off. If the
Red and Yellow LEDs are lit, the Reader is in the standby mode after successful
initialization and diagnosis.
2. Present a Smart[Mifare] card to the reader until you hear a beep and the Green LED is lit.
Then, the Reader will pass the Smart[Mifare] card data on to the Controller and turn on
JP2
JP5
JP3
JP4
Card Output Format
34/26bit Wiegand + RS232
34/26bit Wiegand + RS232
34/26bit Wiegand + RS232
34/26bit Wiegand + RS232
SRK101
V2.0.0
Keypad Output Format
8bit Burst
4bit Burst
34/26bit Wiegand + RS232
34/26bit Wiegand + RS232
14
Jumper Setting
ON
OFF