Menu Basic - Basic Application - WEG MW500 User Manual

5.3.3 Menu BASIC - Basic Application

Seq Indication on the Display / Action
1
Monitoring mode. Press the key ENTER/MENU to
„
enter the 1 level of the programming mode
st
3
When the BASIC group is selected press the key
„
ENTER/MENU
5
If necessary, modify the content of "P0101 -
„
Deceleration Time"
Press the key for the next parameter
„
7
If necessary, modify the content of "P0134 -
„
Maximum Speed"
Press the key for the next parameter
„
9
To end the Start-up routine, press the key BACK/ESC
„
To return to the monitoring mode, press the key
„
BACK/ESC again
Seq
2
4
6
8
Figure 5.6: Sequence of the Basic Application group
Powering up and Start-up
Indication on the Display / Action
The PARAM group is selected, press the keys
„
or until selecting the BASIC group
Basic Application routine is started. If necessary,
„
modify the content of "P0100 - Acceleration Time"
Press the key for the next parameter
„
If necessary, modify the content of "P0133 -
„
Minimum Speed"
Press the key for the next parameter
„
If necessary, modify the content of "P0135 -
„
Maximum Output Current"
Press the key for the next parameter
„
MW500 | 29