Basic Specifications - SATO CT4-ex-RF Operator's Manual

12 Basic Specifications

Print Method
Head Density
(resolution)
Printable Area
Print Speed
Non-printable Area
Form of Media
Thickness
Media size
Outside Diameter/
Core size
Type of Ribbon
Direct thermal/thermal transfer combination
Length 400 mm (15.7ˮ) × Width 104 mm (4.1ˮ) maximum
* Print speed could be limited depending on the type of the printing
layout, media or carbon ribbon.
Pitch direction (Excludes liner) Top: Up to 1.5 mm (0.06ˮ),
Width direction (Excludes liner) Left: Up to 1.5 mm (0.06ˮ),
Media roll, Fan-fold media
* Use genuine media for the printer.
80 to 190 μm (0.08 to 0.19 mm (0.003 to 0.007ˮ))
Continuous Length: 15 to 397 mm/0.6 to 15.6ˮ
Cutter Length:
Partial cut Length: 20 to 397 mm/0.8 to 15.6ˮ
* Values in parenthesis show the size of the liner.
* Size could be limited depending on the number to dispense, media or
operating condition.
Media roll
Outside Diameter: 115 mm (15.6ˮ) maximum
Inside Diameter: 40 mm (1.5ˮ)
Winding Direction: Face-out
Fan-fold media
Maximum Piling Height: 100 mm (3.9ˮ) maximum
Use genuine ribbon for the printer.
12 dots/mm (305 dpi)
2 to 4 inches/sec
(50.8 to 101.6 mm/sec)
Bottom: Up to 1.5 mm (0.06ˮ)
Right: Up to 1.5 mm (0.06ˮ)
(18 to 400 mm/0.7 to 15.7ˮ)
Width: 25 to 115 mm/1.0 to 15.6ˮ
(28 to 118 mm/1.1 to 4.6ˮ)
20 to 397 mm/0.8 to 15.6ˮ
(23 to 400 mm/0.9 to 15.7ˮ)
Width: 25 to 115 mm/1.0 to 15.6ˮ
(28 to 118 mm/1.1 to 4.6ˮ)
(23 to 400 mm/0.9 to 15.7ˮ)
Width: 25 to 115 mm /1.0 to 15.6ˮ
(28 to 118 mm/1.1 to 4.6ˮ)
49