Rs232C High-Speed Serial Interface - SATO /s8408 Operator's Manual

RS232C HIGH-SPEED SERIAL INTERFACE

This High Speed Serial Interface is a Plug-In Interface Module that can be installed in the printer by the user.
INTERFACE SPECIFICATIONS
Asynchronous ASCII
Data Transmission Rate
Transmission Form
Data Length
Stop Bit
Parity Bit
Codes Used
Control Codes
Connector (Printer Side)
Cable Connector
Cable Length
Signal Levels
Protocol
* When READY/BUSY and XON/XOFF are set, single-item buffer or multi buffer can be set in the Interface
Mode. Settings of Compatible Mode can be made in Service Mode.
* Baud rate of 2400bps and 4800bps can be set in Interface Mode.
DIP SWITCH SETTINGS
SWITCH COMPONENT
Data Bit
1
Parity
2 & 3
Stop Bit
4
Baud Rate
5 & 6
Protocol
7 & 8
S8400 Series Operator Manual
Unit 3: Installation
Half-duplex communication
Bi-Directional Communication
2400 *, 4800 *, 9600, 19200, 38400, 57600 bps
Start, b1, b2, b3, b4, b5, b6, b7, b8, Stop (b8 will be omitted if using 7 bit oriented)
7 or 8 bit (selectable)
1 or 2 bit (selectable)
ODD, EVEN, NONE (selectable)
ASC II Character Codes: 7 bits, Graphics: 8 bits
STX (02H), ETX (03H), ACK (06H), NAK (15H)
DB-25S Male (equivalent)
DB-25P Female (equivalent)
5 meters or fewer.
High = +5V to +12V, Low = -5V to -12V
Ready/Busy, X-On/X-Off, Protocol for Driver, Status4, Status5
SETTINGS
ON
OFF
2 3
ON ON
ON OFF
OFF ON
OFF OFF
ON
OFF
5 6
ON ON
ON OFF
OFF ON
OFF OFF
7 8
ON ON
ON OFF
OFF ON
OFF OFF
3-10
7 Bits
8 Bits
Reserved
ODD
EVEN
NONE
2 Bits
1 Bit
57600 bps
38400 bps
19200 bps
9600 bps
STATUS4 (When Compatible Mode is ON: Status2)
STATUS3
X-ON/X-OFF
Ready/Busy
PN: 9001160 (C)