Left Side Output Tray Is Closed - Xerox Phaser 7400 Service Manual

Left Side Output Tray is Closed

The Side Output Tray Detect Sensor indicates the tray is closed. This warning
typically occurs when side output (faceup) is requested and the tray is closed.
Initial Actions:
Cycle the printer's power.
If the problem persists follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Side Output Tray Detect Sensor, PL11.1.32
Side Output Tray, PL2.1.124
COVSNS Harness, PL11.1.34
Troubleshooting Procedure Table
Step Actions and Questions
1
Check the following for evidence of fault or
damage:
Tray Detect Sensor, PL11.1.32
Side Output Tray, PL2.1.124
2
Test the Side Output Tray Detect Sensor.
NOTE: Door sensor tests are located under
the Interlock Switches sub-menu.
Run the Service Diagnostics Side Output
Tray test.
Does the sensor function correctly?
3 Check the sensor connection.
Is P/J180 connected?
4 Replace the Side Output Tray Detect
Sensor.
Does the error persist?
5 Check all pins on the COVSNS Harness for
continuity.
Is the harness conductive?
Error Messages and Codes
Wiring and Plug/Jack References
Print Engine Map 2 (page 10-5)
Print Engine Map 11 (page 10-14)
Print Engine Rear Sensor Board (page 10-29)
Yes
Replace the parts
concerned.
Replace the Engine
Control Board
(page 8-112).
Go to Step 4.
Go to Step 5.
Replace the Engine
Control Board
(page 8-112).
No
Go to Step 2.
Go to Step 3.
Reconnect the
sensor.
Complete
Replace the
COVSNS Harness.
3-179