Jam At Door C For Tray [3][4][5][6] - Xerox Phaser 7400 Service Manual

Jam at Door C for Tray [3][4][5][6]

Media reached the Feed-Out Sensor, but did not arrive at the Transfer Unit Entrance
Sensor on time. This error represents a misfeed jam for media fed from an optional
tray.
Applicable Status Codes:
Code C3:
Jam at Door C for Tray 3
Code C4:
Jam at Door C for Tray 4
Code C5: Jam at Door C for Tray 5
Code C6:
Jam at Door C for Tray 6
Initial Actions:
Try picking paper from a different tray.
Ensure the tray is installed properly and the paper guides are set correctly.
Remove any obstructions or debris in the paper path.
Cycle printer power.
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Feed Rollers
Feeder Assembly
Option Control Board
Feeder Board
Troubleshooting Procedure Table
Step Actions and Questions
1 Check the following for evidence of fault,
dirt, debris, or damage:
Door C
Feed Rollers
Registration Rollers
Transport Rollers
Sensor Actuators
Is there any damage or debris?
2 Check the Option connection.
Is the Option connection to the Printer
damaged or disconnected?
Error Messages and Codes
Wiring and Plug/Jack References
Print Engine Map 3 (page 10-6)
Print Engine Map 5 (page 10-8)
Print Engine Map 11 (page 10-14)
Print Engine Motor Driver Board (6/6) (page 10-36)
Options Map 5, Paper Tray Controller Board
Options Paper Tray Sensors and Interconnect Wiring
Yes
Clean or replace
the appropriate
parts.
Reconnect or
replace the cable.
No
Go to Step 2.
Go to Step 3.
3-23