Error Messages And Codes - Xerox Phaser 7400 Service Manual

Error Message Summary (Continued)
Error Control Panel Message
Printer error - Contact service; report fault [nnn]" (Continued)
Where [nnn] is one of the codes described below.
188 Motor Driver Board Option tray communications error.
221 Tray 3 Firmware Error. Firmware error in Tray 3 Flash Memory.
222 Tray 4 Firmware Error. Firmware error in Tray 4 Flash Memory.
223 Tray 5 Firmware Error. Firmware error in Tray 5 Flash Memory.
224 Tray 6 Firmware Error. Firmware error in Tray 6 Flash Memory.
225 Duplex Unit Firmware Error. Firmware error in Duplex Unit Flash Memory.
226 Motor Driver Board Firmware Error. Software error in Flash Memory.
227 Finisher Inverter Firmware Error. Firmware error in Inverter Flash Memory.
230 CRUM Reader Board not installed or failed.
231 CRUM Reader Interface Failure. A communication error has occurred between
the Engine Logic Board and CRUM Reader Board.
232 CRUM Reader Interface Failure. Error detected in the CRUM Reader Board
transmit circuitry.
233 CRUM Reader Interface Failure. A communications failure has occurred
between the CRUM Antenna and the consumable CRUM.
234 CRUM Reader has detected five or more RFID devices.
242 Tray 3 Flash Memory Failure. Hardware error in the Tray 3 Flash Memory device. 3-155
243 Tray 4 Flash Memory Failure. Hardware error in the Tray 4 Flash Memory device. 3-155
244 Tray 5 Flash Memory Failure. Hardware error in the Tray 5 Flash Memory device. 3-155
245 Tray 6 Flash Memory Failure. Hardware error in the Tray 6 Flash Memory device. 3-155
246 Duplex Unit Flash Memory Failure. Hardware error in the Flash Memory device. 3-156
247 Motor Driver Board Flash Memory Failure. Flash Memory device error.
248 Finisher Inverter Flash Memory Error. Inverter Flash Memory device error.
910 The Tray 2 Lift Motor has failed.
911 The Tray 3 Lift Motor has failed.
912 The Tray 4 Lift Motor has failed.
913 The Tray 5 Lift Motor has failed.
914 The Tray 6 Lift Motor has failed.
917 Error in the Transfer Unit Belt. The Belt Rotation Sensor indicates an error.
918 The Duplex Unit Fan has failed.
919 +24 V not available to the Duplex Unit.
920 Failure in the Yellow Imaging Unit Drum or Motor.

Error Messages and Codes

Page
3-149
3-150
3-150
3-150
3-150
3-151
3-152
3-153
3-154
3-154
3-154
3-154
3-154
3-157
3-158
3-159
3-160
3-160
3-160
3-160
3-162
3-163
3-164
3-165
3-13