Door E Detect Sensor - Xerox Phaser 7400 Service Manual

Door E Detect Sensor

1.
Remove the Exit Assembly (page 8-68).
2.
Release the 2 hooks that secure the Top Output Tray Stack Full Sensor cover.
3. Disconnect the Top Output Tray Stack Full Sensor (P/J160).
4. Release the wire that surrounds the sensor.
5. Release the 2 upper hooks of the Outer Exit Chute.
6.
Separate the outer and inner chutes enough to disconnect the Side Output Tray
Stack Full Sensor (P/J170).
7. Release the 2 lower Outer Exit Chute tabs by gently prying the two chutes apart.
8.
Release the hooks that secure the sensor to the Inner Chute.
Service Parts Disassembly
Latch Locations
Latch Locations
Exit Assembly
s7400-540
8-77