Connecting To A Wireless Network Without Using The Camera's Web Interface - Beward N120 Installation & User Manual

Step 1: create a PIN on the camera and make a note of it.
Step 2: access the router's (access point) web interface and enter your camera's PIN in the
corresponding field of your router's WPS setup page (see your router's manual).
Step 3: click the WPS start button on your router's WPS setup page (see your router's
manual).
Step 4: click the [Refresh] button at Network – Basic – WPS and wait until your wireless
network appears in the list (Pic. 6.3).
Step 5: select your wireless network. For the provided example, the network's name is
BEWARD (Pic. 6.3).
Step 6: click the [Connect] button. After that, you will see the connection progress window.
Step 7: wait for about 2 minutes until the setup process completing.
Once you entered the correct PIN, the connection should be successfully established and
you will see the following text in the connection progress window: Connecting to
AP(BEWARD)...success! (Pic. 6.5). If the camera cannot establish the connection with the access
point, you will see the following text in the connection progress window: Fail! (Pic. 6.6). In this case
repeat steps 1 to 7 for the [PIN] method. If the connection still cannot be established, contact your
system administrator for assistance.
IMPORTANT!
Detailed information on WPS connection of a particular model of a router is not provided in this manual.
Check your router's instructions for details.

6.2.2. Connecting to a Wireless Network without Using the Camera's Web Interface

You can connect to a wireless network without using the web interface of your camera and
your router. To do so, you need to press the WPS buttons on both your camera and your router
within the specified time (2 minutes).
To adjust a wireless connection without using the web interface, follow the steps below:
Step 1: press the [WPS] button on your camera (the button is on the rear side of camera
housing).
Step 2: within 2 minutes, press the [WPS] button on your router.
Step 3: wait for about 2 minutes for configuration completing.
NOTE:
The power LED is blinking violet when the camera is searching for and connecting to a network.
Step 4: check if the camera is available via the wireless connection.
N120 Installation User Manual
Chapter 6. Setting up the Wireless Connection for Windows 7
42