Verifying The Connection To The Wi-Fi Network - Beward N120 Installation & User Manual

6.2.3. Verifying the Connection to the Wi-Fi Network

To verify the connection's status make sure that you can access the camera using the
[Network] menu in Windows OS or the "BEWARD IP Installer" software (UPnP should be
enabled on both your camera and your computer that is used for checking). For details, please see
5.3.2 –
paragraphs 5.3.4.
If UPnP is disabled on your camera, you must define the IP address that was assigned to
the camera by the wireless router. To do so, access the camera through the wired LAN and check
its IP address at Network – Basic – WLAN (Pic. 6.7). Then access the camera using the given IP
address. For detailed information on how to access the camera's web interface, please see
paragraph 5.3.4.
If everything was done correctly, you should access the camera's web interface using the
IP address for the wireless connection.
The Wi-Fi setup using WPS connection is complete.
N120 Installation User Manual
Chapter 6. Setting up the Wireless Connection for Windows 7
Pic. 6.7
43