Table of Contents
Advertisement
IMPORTANT!
When accessing over the Internet, you should note that all cameras inside the local network have the
same public IP address (the IP address assigned by your ISP). To access the cameras through the same
IP address, you must specify the unique port numbers for each camera.
Follow these steps to change the ports of the camera:
IMPORTANT!
It is acceptable to share the same HTTP port between your IP cameras using port forwarding on the virtual
server. However, you must specify a unique RTSP port number for each camera in order to access them
over the Internet.
Step 1: go to
Step 2: in the [RTSP port] field, enter the RTSP port number that is different from the
default one. For this example, we use the RTSP port 3001 (Pic. 7.4).
Step 3: click [Save] to save the changes.
For the next camera you can specify as follows: HTTP port 80, RTSP port 3002.
N120 Installation User Manual
[SETTING] – Network – Advanced – RTSP.
Pic. 7.4
Chapter 7. Accessing the Camera over the Internet
61
Advertisement
Table of Contents
