Beward N120 Installation & User Manual page 41

If you selected the [PBC] method, follow the steps below to set up the network connection:
Step 1: enable WPS on your router. To do so, you can use either of the following methods:
 Press the WPS button on your router.
 Click the button on your router's web interface.
These methods are equivalent. Once WPS is enabled, it will stay active within a certain
period of time. You must complete the rest of the steps within this period (about 2 minutes).
Step 2: click the [Refresh] button at Network – Basic – WPS and wait until the camera
detects your wireless network (Pic. 6.3).
Step 3: select your wireless network in the list. For the provided example, the network's
name is BEWARD (Pic. 6.3).
Step 4: click the [Connect] button. After that, you will see the connection progress window
(Pic. 6.4).
Step 5: wait for about 2 minutes until the setup process completing.
Once the Step 1 is complete, the connection progress window will appear (Pic. 6.4). While
this window is open, the connection is establishing between your router and the camera. If the
connection is established successfully, you will see the following text: Connecting to
AP(BEWARD)...success! (Pic. 6.5). The name of the router (or the access point) your camera is
connected to is shown in the brackets. For the provided example, the router's name is BEWARD.
N120 Installation User Manual
Chapter 6. Setting up the Wireless Connection for Windows 7
Pic. 6.4
40