Table of Contents
Advertisement
If everything was done correctly, you get the camera image on your display (Pic. 5.27).
5.5. Configuring the Camera's Network Settings through the Web Interface
After connecting the N120 to the local network you need to change its network parameters
to get it and your other devices (e.g. computer, laptop etc.) to the same subnet.
IMPORTANT!
To make your camera and your computer work together, the first three parts of their IP addresses must be
identical but the fourth must differ.
For example, the IP address of your computer is 192.168.50.40. An IP address consists of four octets
separated by dots. In the provided example, the 1st octet is 192, the 2nd octet is 168, the 3rd octet is 50,
and the 4th octet is 40. You need to change the IP address of your camera so that the first three octets of
its IP address were the same as your computer's IP address. Therefore, the IP address of your camera
must be of the form 192.168.50.XX. You only need to change the fourth octet to a number different from
the IP address of your computer and other network devices.
N120 Installation User Manual
Chapter 5. Setting up the Wired Connection for Windows 7
Pic. 5.27
30
Advertisement
Table of Contents
