Connecting To A Wireless Network Without Using The Camera's Web Interface - Beward N13103 Installation & User Manual

Wi-fi, megapixel cmos sensor, 16 channel surveillance software included, built-in multi-zone motion and audio detection

Table of Contents

If you selected the [PIN] method, follow the steps below to set up the network connection:

Step 1: create a PIN on the camera and make a note of it.

Step 2: access the router's (access point) web interface and enter your camera's security

PIN in the corresponding field of your router's WPS setup page (see your router's manual).

Step 3: click the WPS start button on your router's WPS setup page (see your router's

manual).

Step 4: click the [Refresh] button at SETTING – Network – WPS and wait until your

wireless network is discovered (Pic. 6.3).

Step 5: select your wireless network. For the provided example, the network's name is

BEWARD (Pic. 6.3).

Step 6: click the [Start] button. After that, you will see the connection progress window.

Step 7: wait for about 2 minutes until the setup process is complete.

Once you entered the correct PIN, the connection should be successfully established and

you will see the following text in the connection progress window: Connecting to

AP(BEWARD)...success! (Pic. 6.5). If the camera cannot establish the connection with the access

point, you will see the following text in the connection progress window: Fail! (Pic. 6.6). In this

case, repeat steps 1 through 7 for the [PIN] method. If the connection still cannot be established,

contact your system administrator for assistance.

IMPORTANT!

Detailed information on how to setup WPS on a particular model of a router is not provided in this manual.

Check your router's instructions for details.

6.2.2. Connecting to a Wireless Network without Using the Camera's Web Interface

You can connect to a wireless network without using the web interface of your camera and

your router. To do so, you need to press the WPS button on both your camera and your router

within the specified time (2 minutes).

To setup a wireless connection without using the web interface, follow the steps below:

Step 1: press the [WPS] button on your camera.

Step 2: within 2 minutes, press the [WPS] button on your router.

Step 3: wait for 2 minutes for configuration to complete.

NOTE:

The power LED is red when the camera is searching for a network and setting up the connection.

Step 4: check if the camera is available via the wireless connection.

N13103 Installation User Manual

Chapter 6. Establishing and Configuring the Wi-Fi Connection

Table of Contents