Back Pane - Beward N120 Installation & User Manual

3.2. Back Pane

Power connector: for 5 V, 1 A DC power supply.
It is recommended to use the original power supply only for correct camera's operation.
MicroSD card slot: provides recording of information on the microSD/SDHC memory
cards. In case of disconnection an option of automatic backup recording is also available.
Reset button: when the camera is switched on, press this button to reboot the camera.
Press and hold this button for at least 10 seconds to reset the camera to factory defaults. If you
hold this button during less than 10 seconds, the camera will reboot without reset to factory
defaults.
WPS (Wi-Fi Protected Setup) button: this button provides simplified mechanisms to
configure secure wireless networks. To do so, press the WPS button on the camera and then
press the WPA button on the device which you want to connect the camera to. After that, the
wireless connection between the camera and the device will be established within 2 minutes.
Network connector: is used for connection to LAN or to the Internet by a RJ-45 connector.
Wi-Fi LED: lights when the camera is connected to the wireless network.
 Blinking blue: the camera is connected to a wireless network.
 Unlit: the camera is not connected to the wireless network or the LED indicator is turned
off.
Wi-Fi connector: RP-SMA connector for connecting Wi-Fi antenna.
Moreover, there are a screw hole for attaching a bracket on the rear side and a label which
contains the following information:
 SN: IP camera serial number
 MAC: IP camera MAC address (LAN)
 WMAC: IP camera MAC address (WLAN)
N120 Installation User Manual
Pic. 3.2
Chapter 3. Product Description
8