How To Upgrade Firmware - EverFocus EDR810H Insruction Manual

Upgrade Firmware
This chapter will try to give you a detailed instruction on how to upgrade
the DVR. This will be a helpful in completing the upgrading process.
Please go to
upgrade folder. Then click on the folder that represents you're the model
number of your DVR.
Copy the .ETW to your USB memory from your computer
Insert the USB in to the USB slot on the front panel of the DVR. When
inserting the USB, make sure the direction of insertion is correct.
If you are in Record mode hit the stop button to stop recording.
If the menu pops up when you press the stop button. This usually means
you have either the DVR is in Timer record or Motion record. Log into the
DVR menu by pressing the Menu button. Go to Either Timer Setting Menu
or Motion Record Setting menu and turn them off.
Once you have stopped any type of recording on the DVR you are ready to
upgrade.
Press the menu button and use the Jog Dial to go to System menu.
Using the enter button to navigate in the menu. Highlight System
Upgrade turn NO to YES (use jog wheel to select).
Highlight YES again and press enter (use jog wheel to select).
Next to System Upgrade you will notice it say "1/3"
Once you have read success log out of the menu by pressing the menu
button twice. Then turn the power on the DVR off and turn it back on.
ftp://208.50.31.200
76
Chapter
9
and go to DVR Firmware