Event Recording Setup - EverFocus EDR810H Insruction Manual

4.3 Event Recording Setup

We will define two event recording types ALARM and MOTION. After the
event recording is enabled, the EDR810/410 will start an event recording
when an event occurs. For instance when motion activity is detected by the
DVR it will begin recording at the specific IPS set under event column. Or
when an alarm is detected by the DVR it will begin recording at the specific
IPS set under event column.
In order to start an event recording, you will NEED to perform the following:
1. Enable the event in each event (alarm or motion menu) setting first.
For example (motion), enable Camera 2 in the MOTION SETUP
MENU (shown as below). You can enable multiple alarm or motion
triggers.
2. After enabling an event, you need to set a time period (TP) in the
SCHEDULE SETUP MENU. An event recording must be set in
a scheduled time period (TP). You can refer to the SCHEDULE
SETUP MENU for time period configurations (Chapter 3.8).
Diagram 4.2
60