EverFocus EDR810H Insruction Manual page 37

DURATION: The amount of time a motion event will record - from 1
sec to 99 seconds. The default value is 5 seconds. To change this, simply
use the Jog Dial on the DVR. Press the Enter key to make your selection.
ALARM OUTPUT: This will transmit a signal to another device. The
setting of alarms are NONE = not activated and 1 = one output
signal transmitted. To change this, simply use the Jog Dial on the DVR.
Press the Enter key to make your selection.
EMAIL/NETWORK:
YES: Sends an email
NO: Does not send an email
The email address and e-mail server can be set in the NETWORK
SETUP MENU.
NETWORK ALARM:
YES: Enables alarm network when motion occurs.
NO: Disables alarm network when motion occurs.
BUZZER: Motion buzzer.
ENABLE: To enable a motion buzzer.
DISABLE: To disable a motion buzzer.
BUZZER: Audible buzzer when motion is detected.
MAIN MON: Display on a main monitor when an alarm occurs.
NO CHANGE: No change on the display in the main monitor when
an motion occurs.
FULLSCREEN: A full screen of the active camera will display when
CALL MON: Display on a call monitor when motion occurs.
motion occurs.
29