Motion Setup Menu - EverFocus EDR810H Insruction Manual

3.5 Motion Setup Menu

Diagram 3.8 is a screen shot of the MOTION SETUP MENU. We define motion
as a change of pixilation in the field of view, which is detected by the digital video
recorder, and triggering the recorder to start recording. This menu is for setting up the
digital recorder for motion recording on a per camera basis. In the MOTION
SETUP MENU the following fields are defined as follows:
MOTION: This field is to turn motion recording on or off. The Default
from the factory is set to off or disabled. Motion is also considered an
event. To change this, simply use the Jog Dial on the DVR. Press the
Enter key to make your selection.
ENABLE: Enable motion detection.
DISABLE: Disable motion detection.
Note: Motion only works in live and playback modes. It is
invalid when you are setting menus.
SENSITIVITY: The sensitivity allows users to adjust to a suitable
motion detection sensitivity. There are 10 sensitivities available; level 1 is
the lowest, and level 10 is the highest sensitivity. To change this, simply
use the Jog Dial on the DVR. Press the Enter key to make your selection.
Diagram 3.8
28