Remote Control; Reset; Power - Extron electronics XTP CrossPoint 1600 Setup Manual

XTP CP 4o HDMI (HDMI output board)
OUT
2e 2e 2e
HDMI connectors — Connect an HDMI video display
2e
to each of these ports.
HDMI connectors
NOTE: See
connector to the board with a LockIt HDMI Cable Lacing
Bracket.
Audio (local audio) connectors — Connect audio
2f
devices, such as audio amplifiers or powered speakers
to these 3.5 mm, 5-pole captive screw connectors to
receive unamplified, line level audio (see
connectors on page 15 to wire the connectors).
XTP CP 4o DVI Pro (DVI Pro output board)
OUT
2g 2g 2g
DVI connectors — Connect a DVI video
2g
display to each of these ports.
Audio (local audio) connectors — Connect audio
2h
devices, such as audio amplifiers or powered speakers
to these 3.5 mm, 5-pole captive screw connectors to
receive unamplified, line level audio (see
connectors on page 15 to wire the connectors).
XTP CP 4o SA (Analog audio output board)
OUT
Audio (local audio) connectors — Connect audio
2i
devices, such as audio amplifiers or powered speakers
to these 3.5 mm, 5-pole captive screw connectors to
receive unamplified, line level audio (see
connectors on page 15 to wire the connectors).
10 XTP CrossPoint 1600 and 3200 • Installation
XTP CP 4o HDMI
AUDIO
L R L R L R L R
2e 2f
on page 14 to secure the
L R
Local audio
XTP CP 4o DVI Pro
AUDIO
L R L R L R L R
2g 2h
L R
Local audio
XTP CP 4o SA
AUDIO
L R L R L R L R
2i
L R
Local audio

Remote Control

c
LAN (Ethernet) port — If desired, connect a network WAN or LAN
hub, a control system, or a computer to the Ethernet RJ-45 port (see
TP connectors
on page 12 to wire the connector).
NOTE: The factory default IP address is 192.168.254.254.
d
Remote RS-232/RS-422 port — If desired, connect a third-party
control system or computer to the rear panel Remote RS-232/RS-422
port (see Remote port connector
connectors).
NOTE: The XTP System Configuration software CANNOT
interface with the switcher via the Remote RS-232/RS-422
port. A third-party control system or a computer issuing SIS
commands can use this port.

Reset

e
Reset button — Initiates four levels of reset of the matrix switcher.
For different reset levels, press and hold the recessed button while
the switcher is running or while you power up the switcher.
See the XTP CrossPoint 1600 and 3200 Series User Guide, available
on the Extron DVD or at www.extron.com.

Power

f
Power connectors — Plug the switcher into a grounded AC
source.
XTP CrossPoint 1600 and 3200 • Installation
on page 16 to wire the
11