Remote Control; Selected Sis Commands; Establishing A Network (Ethernet) Connection - Extron electronics DTP CrossPoint 108 4K Setup Manual

Remote Control

This section describes using the remote control features of the
DTP CrossPoint 4K Series. Topics that are covered include:

Selected SIS Commands

•
Installing and Starting the Control Programs
•
• Accessing the HTML Pages
Selected SIS Commands
You can use SIS commands for operation and configuration of the
switchers (see
Switcher Commands
from the PC connected to an AV LAN port (IPCP models) or the
LAN port (non-IPCP models) (
( S on page 10), or USB port (

Establishing a Network (Ethernet) Connection

NOTE:
port, you may need to change the default settings (IP address,
subnet mask, user name, and administrator or user password)
of the IPCP controller or switcher.
Establish a network connection as follows:
1. Open a TCP socket to port 23 using the switcher IP address.
NOTE:
The switcher responds with a copyright message including the
name, firmware version, and part number of the product, and
the current date and time.
NOTES:
2. If necessary, enter the appropriate password.
If the password is accepted, the switcher responds with
User
If the password is not accepted, the
22 DTP CrossPoint 4K Series • Remote Control
SIS Command and Response Table for Matrix
on page 24). You can run these commands
The first time you connect to the switcher via the LAN
The factory default IP address is 192.168.254.254.
• If the switcher is not password-protected, the device is
now ready to accept SIS commands.
• If the switcher is password-protected, a Password
prompt appears.
• The factory configured passwords for all accounts on
this device have been set to the device serial number.
In the event of a complete system reset, the passwords
convert to the default, which is no password.
or Login Administrator
R Q
or on page 10), serial port
A on page 16).
.
Password
Login
prompt returns.