Extron electronics XTP CrossPoint 1600 Setup Manual page 8

XTP CP 4i DVI Pro (DVI Pro input boards)
IN
1g 1g 1g
DVI connectors — Connect up to four DVI
1g
cables between these ports and the DVI
output port of the digital video sources.
Audio (local audio) connectors — Connect
1h
balanced or unbalanced stereo audio inputs to these
3.5 mm, 5-pole captive screw connectors (see
audio connectors
XTP CP 4i VGA (Universal analog video input boards)
IN
1i 1i 1i
VGA connectors — Connect up to four VGA
1i
cables between these ports and the analog
audio output port of the video sources.
NOTE: These universal analog video boards can accept RGB
video and (with adapters) component video, S-video, and
composite video (see
to wire the connectors for various analog video formats).
Audio (local audio) connectors — Connect
1j
balanced or unbalanced stereo audio inputs to these
3.5 mm, 5-pole captive screw connectors (see
audio connectors
8 XTP CrossPoint 1600 and 3200 • Installation
XTP CP 4i DVI Pro
AUDIO
L R L R L R L R
1g 1h
L
Local
on page 15 to wire the connectors).
AUDIO
L R L R L R L R
1i 1j
Analog video connectors
on page 15
L
Local
on page 15 to wire the connectors).
OUT
SIG LINK
PWR
XTP
2b 2a
R
XTP CP 4i VGA
R
b
—
Output boards space Make connections to installed output
boards as desired.
XTP CP 4o (XTP output board)
SIG LINK SIG LINK SIG LINK
PWR PWR PWR
LAN XTP LAN XTP LAN XTP LAN
2c 2b 2a 2c 2b 2a 2c 2b 2a 2c
XTP output connectors — Connect a TP cable
2a
between this connector and a compatible Extron
XTP receiver (see TP connectors
wire the connector).
XTP Power indicators — Light or blink to indicate the status
2b
of the power over XTP that the output board is providing to the
receiver endpoint as follows:
Lit green — The board is providing XTP power to the endpoint.
Lit amber — XTP Power is available for the endpoint, but it is
disabled in the matrix switcher.
Flashing amber — No XTP power is available for the endpoint,
but it is enabled in the matrix switcher.
Lit red — A wiring fault exists.
Unlit — The endpoint is not capable of receiving power over XTP.
LAN connectors — As desired, connect a TP cable
2c
between a host device or control LAN and this
connector for passive extension to the LAN (Ethernet)
connector on the connected endpoint (see
connectors
on page 12 to wire the connector).
RS-232/IR Over XTP connectors — If desired,
2d
connect serial RS-232 signals, modulated IR signals,
or both to these 3.5 mm, 5-pole captive screw
connectors for bidirectional RS-232 and IR
communications on the associated inputs (see
connectors
on page 14 to wire the connectors).
XTP CrossPoint 1600 and 3200 • Installation
XTP CP 4o
IR/RS-232 OVER XTP
RS-232 IR RS-232 IR RS-232 IR RS-232 IR
Tx Rx Tx Rx Tx Rx Tx Rx Tx Rx Tx Rx Tx Rx Tx Rx
2d
SIG LINK
PWR
on page 12 to
XTP
LAN
TP
RS-232 IR
Tx Rx Tx Rx
RS-232 and IR
9