Operating Instructions - GRAUPNER mc-16 Programming Manual

Operating Instructions

Opening the Transmitter case
The removable back of the case is held by one
locking catch and two interlock sliding catches.
Before opening the Transmitter ensure the power
switch is OFF. The sliding catches are moved
against the direction of arrow (inward) until they hit
the stop, then case back can be opened. To close,
insert the case back into the housing at the lower
edge. Push it closed and then slide both caches in
direction of the arrow (outward).
6 General Section
Changing the proportional control sticks and
changing the centring force.
Both vertical control stick directions can be changed
between centring or non-centring (e.g. throttle on the
right or left). With the transmitter open and at the
appropriate centring lever, notice the feather/spring
(figure below. Lift up the centring lever to be able to
get access, remove and keep the spring.
In the case of mechanical conversion of the throttle
function, an electronic conversion of the control
functions must also be made using the code "MOD"
during the basic transmitter programming, see page
15. The ratchet strap provided in the accessories is
mounted to the two captive nuts on the inside of the
control stick units (photograph on the right).
The resistance to movement of the control stick can
be adjusted between low to high by tightening or
loosening of the adjusting screw.
The centring force of the control sticks can be
adjusted at the screws indicated in the figure by an
arrow:
Clockwise rotation – centring force higher
Anti-clockwise rotation - centring force lower