GRAUPNER mc-16 Programming Manual page 84

NAUTIC Multi-Prop Modules
Only available in PPM Mode
Optional Transmitter Module
NAUTIC Multi-Proportional Module
Part No. 4141
Up to two modules are connectable,
(Described on page 92)
Function Notes
The NAUTIC Multi-Prop module allows
two proportional function channels be
split into eight proportional channels,
i.e. at the receiver connections three
additional servo connections are
available per module. Two prop.
module can transmitter lateral be
inserted
84 Nautic
Fitting and connection to the mc-16/20
transmitter.
The modules are installed as shown in the
instructions on page 8/9 of this manual.
If the NAUTIC program in system menus
"NA7" and/or. "NA8" are switched to "ON"
(sees page 16), control paths 7 and/or 8
are automatically reserved for NAUTIC
modules dependent on the model type.
Model Type NAUTIC Channels
FL (Standard) 7 and 8
UN (Unifly) 7 and 8
Fb (F3B/Butterfly) 7 and 8
AC (Acrobatic) 7 only
HE (Helicopter) 7 only
The 5-pole connector of the module should
to be inserted, e.g. into socket "CH7", and
the 4-pole plug on the single-wire cable
connected to the "NAUTIC" socket on the
transmitter plate. If necessary a second
module can be connected to "CH8". The 4-
pole plug of the 2nd module is connected to
the module already inserted.
Both model types "AC" and "HE" can
additionally, if necessary, use channel 5 as
well as channel 7 for the NAUTIC modules,
under the following conditions:
1. Servo reverse (page 21) NORM
2. Servo Neutral Point (page 21)
3. Servo Travel (page 21) ±146%
The setting is most easily done before
inserting the proportional or switch
modules (Part No. 4152 or 4151).
During the servo travel setting when the
NAUTIC modules are connected the
display can flicker, which makes
reading the exact value more difficult.
4. AC: Code "AUTOLANDING"
if using ch 7 (page 57, 58)
5. HE: Code "GYRO-CONTROL"
if using ch 7 (page 78, 79)
6. HE: Code "SWASHPLATE TYPE"
if using ch 7 (page 66) Type 2 or 3
The transmitter set-up for the NAUTIC
modules is now complete.
0
OFF
OFF