Elevator; Flap - GRAUPNER mc-16 Programming Manual

If the "ALD" subroutine were previously switched off
by pressing , can move the elevators, flaps
CLEAR
and airbrake to their pre-determined auto-landing
positions by operating external switch 5.
The settings for the control surfaces must be
determined experimentally during flight and then
adapted to the requirements.
Warning:
If the automatic manoeuvre, see page 56 is
simultaneously switched on, it will be inactive when
control function 1 is below the switching point for
auto-landing!
58 Fixed Wing Models
COMBI-MIX
Aileron Rudder Mixer
(access via Set-Up Menu)
In the case of operating the ailerons, the rudder is
deflected by a programmable mix proportion. The
rudder can, however, be steered separately at any
time with priority.
After call of the code "A-R", the mix proportion is
adjusted using the / buttons and is stopped
INC DEC
to automatically at the maximum value of ±125%.
The combi mixer can also be disabled by an external
switch attached to socket 3 on the transmitter board.

FLAP

ELEVATOR

MIXER
Flap Elevator Mixer
(access via Set-Up Menu)
To assist the elevator with close turning flight and
aerobatics, the flaps can be linked to the elevator
and are driven out proportionally to the increase the
wing lift. The value in the code "E-F" can be varied
using, the and buttons between 0 and
INC DEC
±125%. The mixer can be also switched off with an
external switch connected to socket 4.