Teacher / Pupil - GRAUPNER mc-16 Programming Manual

Teach – Pupil System
with Fibre-Optic Cable
Opto-electrical Teach-Pupil System with Fibre-optic cable
Part No. 3290
The teacher and pupil transmitters may be
operated only in the PPM mode.
For connection between transmitter types
D 14, FM 414, FM 4014, FM 6014,
FM 6014 / PCM 18, mc-14, mc-15, mc-16,
mc-16/20, mc-17, mc-18 and mc-20.
With this option and operation of the
integrated momentary switch allows all
control functions of the teacher's
transmitter to be transferred to the pupil's
transmitter.
It is necessary that the pupil's transmitter
contains all the same programming, mixing
and coupling functions as the teacher's
transmitter as this data is not transferred.
For the installation of the teacher-pupil
training system in teacher transmitter, it is
required to drill a further hole into the right
or left facia plate using a 6 mm drill. Please
you make sure that no metal debris enters
the inside the transmitter – there is a risk
of short circuits!
96 Supplement
Function Notes
Switch the transmitters into PPM mode.
Plug M of the teacher-pupil cable into
teacher's transmitter, and insert plug S into
the pupil's transmitter. Both the teacher
and pupil transmitters, must be equipped
with suitable transmitter battery.
The HF radiation takes place from the
teacher's transmitter and an appropriate
crystal must be the installed. The pupil's
transmitter needs no HF module
The change-over of control from teacher to
pupil takes place by the teacher holding
the momentary switch on his transmitter.
The teacher need only release the switch
to regain control of the model, resume
normal flight attitude before handing
control back to the pupil again.
Replacement Parts
Part No 3290.4 Fibre-optic cable for
teacher-pupil system.
Module for additional pupil transmitters
Part No. 3290.3
Installation in the Teacher's Transmitter
After installation of the teacher printed
circuit board in teacher transmitter (board
with switch and socket).
Disconnect the plug on the transmitter
board from the HF Module and plug this
into the socket on the teacher PCB.
Connect the lead soldered to the teacher
PCB to the HF Module.
Troubleshooting:
•
The interface is not correctly
connected to the HF Module.
•
Pupil's transmitters is not switched on.
•
Pupil's transmitters is not in PPM
mode.
•
The fibre-optic cable is damaged.
•
The optical cable has worked loose
from one of the sockets. In this case
release the clamping device in the
plug by pressing down as shown and
push the fibre-optic cable back in.
Installation in the Pupil's Transmitter
After installation of the board, unplug the
HF Module lead at the transmitter board
and connect the lead from the module in
it's place.