Flap; Wing Type - GRAUPNER mc-16 Programming Manual

WING TYPE

PROGRAMS
Wing Mixer for Delta and Flaperon models
(access via Set-Up Menu)
After calling this program "WNG OF" appears in the
Info-Display . Two special mixers are available with
this code, which can be selected using INC/DEC.
1. For Delta models, "DLT" combines the functions
of Ailerons and Elevators, where the servos are
connected to receiver outputs 2 and 3 (Throttle
to 1, Rudder to 4). The mix ratio is adjusted using
the code "Dual-Rate" (Control function 2 for
Ailerons and 3 for Elevator, see page 20).
Note:
Depending on the installation of the servos, the direction of
rotation and neutral position may be adjusted using the
appropriate codes on page 21.
Servo travel adjustment:
Ch 2 affects the servo travel for servo 2.
Ch 3 affects the servo travel for servo 2 during aileron control,
but it affects both Servos 2 + 3 together during elevator travel.
For safety reasons, the servo travel must amount to at least
50%!
2. Aileron / Flap mixer: "FPR" stands for Flaperon
and affects two servos attached to receiver output
2 and 6 as follows:
● Aileron, if the control stick for control function 2
is moved.
● Flap, if the control element for function 6 is
moved.
Note:
Depending on the installation of the servos, the direction of
rotation and neutral position may be adjusted using the
appropriate codes on page 21.
Servo travel adjustment:
Servo 2 can be altered using the code servo travel adjustment
for "CH2". The setting for "CH6" affects both exits when
control function 6 is used for the flap position.
The mix portion of the aileron control, function 2. can be
changed using the Dual-Rate and Exponential settings. The
setting doe CH2 affects both outputs 2 and 6 together.
Fixed Wing Models 59