GRAUPNER mc-16 Programming Manual page 86

NAUTIC Expert Switch Function Modules
Only available in PPM Mode
Optional Transmitter Module
16 Channel NAUTIC Expert Module
Part No. 4108
Up to two modules are connectable,
(Described on page 92)
Function Notes
The NAUTIC Expert module extends two
proportional channels to 16 signal
paths. All eight switches have a central
position, providing a genuine forwards–
stop–backwards function, if at the
receiver a switch module, Part No.
3754.1 or a Dual-Switch module Part No.
3754.2 is used. Of the 8 switches, 3
switches are sprung-off and 2 are
sprung-off in one direction. The
remaining 3 switches are intended for
forwards–stop–backwards functions
and are not self-centring.
Transmitter-laterally two modules with
altogether 32 switching functions can be
installed onto the module blow-out.
86 Nautic
Fitting and connection to the mc-16/20
transmitter.
The modules are installed as shown in the
instructions on page 8/9 of this manual.
If the NAUTIC program in system menus
"NA7" and/or. "NA8" are switched to "ON"
(sees page 16), control paths 7 and/or 8
are automatically reserved for NAUTIC
modules dependent on the model type.
Model Type NAUTIC Channels
FL (Standard) 7 and 8
UN (Unifly) 7 and 8
Fb (F3B/Butterfly) 7 and 8
AC (Acrobatic) 7 only
HE (Helicopter) 7 only
The 5-pole connector of the module should
to be inserted, e.g. into socket "CH7", and
the 4-pole plug on the single-wire cable
connected to the "NAUTIC" socket on the
transmitter plate. If necessary a second
module can be connected to "CH8". The 4-
pole plug of the 2nd module is connected to
the module already inserted.
Both model types "AC" and "HE" can additionally, if necessary, use channel 5 as well as
channel 7 for the NAUTIC modules, under the following conditions:
1. Servo reverse (page 21) NORM
2. Servo Neutral Point (page 21)
3. Servo Travel (page 21) ±146%
The setting is most easily done before
inserting the proportional or switch modules
(Part No. 4152 or 4151). During the servo
travel setting when the NAUTIC modules
are connected the display can flicker, which
makes reading the value more difficult.
4. AC: Code "AUTOLANDING"
if using ch 7 (page 57, 58)
0
5. HE: Code "GYRO-CONTROL"
if using ch 7 (page 78, 79)
6. HE: Code "SWASHPLATE TYPE"
if using ch 7 (page 66) Type 2 or 3
OFF
OFF