Software Structure - GRAUPNER mc-16 Programming Manual

System Menu
Using the system for the first time and programming
the basic transmitter data

Software Structure

The software is divided into two menus, which are
activated in different ways.
1. System Menu
Adjusting the basic transmitter functions.
2. Set-Up Menu
Selecting, activating and programming the model
specific data.
In each of these menus, the individual codes can be
called up in rotation by the
ROLL UP
(Roll Down, downwards) buttons. When
ROLL DN
you reach the bottom code, the ROTART SELECT
system returns you to the start of the list again, until
you either leave the System or Set-Up Menu by
pressing ( and
ENTER ROLL UP ROLL DN
simultaneously), or by switching off the transmitter
and thereby resetting it to normal operation.
To prevent accidental reprogramming, the System
Menu can only be activated if the transmitter is
switched off first. This makes it impossible for you to
accidentally alter programmed these functions, e.g.
switching model memory or changing modulation
mode (FM-PPM/PCM), while you are using the
system to control a model. Since the transmitter is
not producing a modulated signal in this mode, it is
impossible to transmit a signal to the receiver during
this basic programming.
Basic method of using the System Menu
First you need to select the code you wish to alter by
pressing the or
ROLL UP ROLL DN
this code, you select the function you require using
the or buttons.
INC DEC
14 System Menu
Entering the System Menu
Simultaneously press the
buttons (=
ENTER
An acoustic signal sounds. The program is now in
the System Menu. The accompanying flow chart
shows the programs of the primary system, whose
functions are shown in the transmitter display. By
repeat pressing of
basic programming and automatically returns to
normal transmitter operation.
(upwards) or
keys
button. Within
and
ROLL UP ROLL DN
) whilst turning the transmitter on.
the software leaves the
ENTER
Block diagram of the System Menu
Leave the Menu at any place with ENTER .