GRAUPNER mc-16 Programming Manual page 61

Programming a Helicopter, model type "HE"
The initial set-up of the transmitter for helicopter
models is achieved using the System Menu, see
pages 14 – 17. The basic set-up depends less on the
model itself than on the general control preferences
of the pilot.
The most important setting, above all others, is the
control mode (MOD), including whether the throttle
stick should pushed or pulled for maximum pitch
(THR). Both settings should be reviewed in all cases
before beginning with the set-up of the model.
The model dependent parameter settings are
grouped in the Set-Up Menu, that is activated from
the initial position of the transmitter and/or leaving
the System Menu by pressing of the key
In both menus, the desired functions are displayed
by scrolling through the options by pressing the
and/or buttons.
ROLL UP ROLL DN
Connection of external control elements to the
transmitter board for the helicopter program
In the helicopter program, you can connect up to
eight external switches, which have the following
functions :
0 Dual Rate / Exponential Roll
1 Dual Rate / Exponential Pitch
2 Dual Rate / Exponential Tail Rotor
3 Autorotation
4 Throttle and Collective Pitch curve (1)
5 Throttle and Collective Pitch curve (2)
6 Static & Dynamic mixers and freely
programmable mixer B
7 Gyro control and freely programmable mixer A
.
ENTER
Also on the board of the transmitter are additional
connectors that allow the installation of two slider
controls for the following functions:
CH6 Collective Pitch Trim
With this slider control the Collective Pitch
setting can be adjusted independently to the
throttle servo up to around 25% of the
maximum servo travel.
CH7 Setting for the Gyro
Helicopter 61