Model Select; Receiver Connections - GRAUPNER mc-16 Programming Manual

DATA
INITIALISATION
Reset, erase data & reprogram the basic values
(access via System Menu)
Before you re-program a model memory, you should
reset all data using this code in order to ensure that
all parameters and functions are reset to the default
settings.
When you select the "RST" function, the number of
the model memory in the bottom line of the display
flashes. This is the memory whose settings are to be
erased. The actual erasure occurs when you press
the button. As soon as the model number
CLEAR
ceases to flash the erasure has taken place.
Re-initialised data after reset:
In the System Menu:
Model Name Model number and current model type
Throttle Direction Normal ("NORM")
NAUTIC program off ("OF")
The settings for type of modulation, model number, stick mode
and model type are unchanged.
In the Set-Up Menu
Dual-Rate = 100%
Exponential = Linear ("LN")
Servo Reverse = Normal ("NORM")
Servo Neutral = 0
Servo Travel = 100%
Mixer Values = Initial default values

MODEL SELECT

Switching Model Memory 1 – 20
(access via System Menu)
The mc-16/20 transmitter allows you to store all the
settings for 20 different models.
After selecting the System Menu code "MDL", by
pressing the or
ROLL UP ROLL DN
the or buttons to select the model. All the
INC DEC
adjustments which you subsequently make will then
apply to the model number displayed in this menu.
The model type can be called up in the display by
pressing the button.
CH SEL

Receiver Connections

(Channels 1 – 8)
The servos must be connected to the receiver
outputs as shown in the diagrams below:
button, press
See the Helicopter section for those connections.
System Menu 17