Door adjustment procedure:
1. Unscrew completely the locking pin (see picture below).
2. To increase the pressure of the door on the gasket, turn the handle counter clockwise; to decrease the pressure
of the door on the gasket, turn the handle clockwise until desired pressure is attained.
3. Then screw back the locking pin about 1/4" deep and make sure you lock it in place with the nut.
6. REPLACEMENT PARTS
Your PSG furnace is designed to burn clean and requires little maintenance. It's recommended to conduct a visual
inspection at least once a month to uncover any damage to the unit. Any defect must be repaired without delay
using genuine PSG replacement parts. You can find a complete list of replacement parts in our website at
distribution.com.
DOOR GLASS
•
Inspect the glass regularly to detect any glass failure. If you find any defect, stop using the furnace
immediately. Never operate a wood furnace with a broken glass.
•
If you have to change your door glass, you must use Pyroceram 3/16" (5mm) thick. Use genuine parts sold
by a PSG authorized dealer.
•
To replace the glass, remove the screws that hold the glass retainers in place. Removed these retainers
and replace the defective glass; the glass gasket should be replace at the same time. To put back in place,
reverse the procedure.
•
Do not used abrasive cleanser. Special cleansers for wood stoves glass are available in any good hardware
store.
•
Clean glass ONLY when the unit has cooled down.
GASKET
We recommend to replace gasket that seals the door once a year, in order to maintain a good control of the
combustion for maximum efficiency and security. To replace your door gasket, remove the old gasket and glue.
Clean the surface thoroughly, apply glue sold for that particular use, and put the new gasket onto the door. Wait for
at least 2 hours before lighting your furnace.
Locking pin
16
www.psg-