Wood Or Wood/Electric Combined Furnaces; Introduction; Chimney And Draft; Safety Rules - PSG 15 Kw Installation And Operating Instructions Manual

SECTION A:

INTRODUCTION

Take note that this furnace operates like an EPA wood burning stove. This applies to the lighting, the embers and
the minimum combustion air intake which depends on the type and the grade of the combustible.
This model line is certified as meeting the emissions limits in 40 C.F.R. part 60, section 60.532 (B) per EPA
methods 28 and 5G-3, February 1988.
To optimize the efficiency of your furnace, here are few advices you should follow when installing or operating
your Caddy
.
Respect the local codes (when in doubt, consult your local dealer).
Make sure your furnace is installed according to the instructions on the certification plate.
All controls adjustments must be performed by a qualified technician. The controls settings and the blower speed
must conform to the recommendations of the National Warm Air Heating and Air Conditioning Association and
respect the recommended static pressure ranges in the warm air bonnet of the furnace (see General Technical data
static pressure).

1. CHIMNEY AND DRAFT

This furnace must be connected to a chimney certified for use with wood burning heating appliances; a 7 inch
chimney and connector are recommended for the Caddy (see 3.Appliance installation, paragraph C).
If draft exceed –0.06 in. W.C a barometric damper should be installed on the smoke pipe.
Never install a manual damper.
The barometric control must be adjusted so that the maximum draft measured at the furnace outlet does not
exceed -0.06 in. w.c. Please note that a draft exceeding -0.06 in. w.c. will reduce the efficiency and could produce
an uncontrollable fire. On the other hand, the minimum draft required is -0.04 in. w.c. in the evacuation pipe
on the wood side, no matter what type of furnace (WOOD, WOOD / ELECTRIC OR WOOD / OIL).

2. SAFETY RULES

GENERAL REQUIREMENTS

Make sure the chimney outlet and the pipes are clean and in good condition.
Do not use chemical products or liquids to light the fire.
Do not burn wood coated with paint, glue or chemical products.
Do not burn wastes or flammable liquids such as gasoline, naphtha or motor oil.
Do not install an automatic feeder on this furnace.
Do not store wood in the vicinity of the furnace. Respect the required clearances between combustible materials
and the source of heat.

WOOD OR WOOD/ELECTRIC COMBINED FURNACES.

Average emissions rate: 6.56 g/hr
Average heating efficiency: 71.43%
3