Replacement Parts; Door Glass; Gasket - PSG MAX CADDY Installation And Operating Instructions Manual

6. REPLACEMENT PARTS

Your PSG furnace is designed to burn clean and requires little maintenance. It is recommended to conduct a visual
inspection at least once a month to uncover any damage to the unit. Any defect must be repaired without delay
using genuine PSG replacement parts. You can find a complete list of replacement parts in our website at
distribution.com.
6.1

DOOR GLASS


Inspect the glass regularly to detect any glass failure. If you find any defect, stop using the wood furnace
immediately. Never operate a wood furnace with a broken glass.

If you have to change your door glass, you must use Pyroceram 3/16" (5mm) thick. Use genuine parts sold
by a PSG authorized dealer.

To replace the glass, remove the screws that hold the glass retainers in place. Removed these retainers
and replace the defective glass; the glass gasket should be replace at the same time. To put back in place,
reverse the procedure.

Do not use abrasive cleanser. Special cleansers for wood fireplaces glass are available in any good
hardware store or specialty hearth retailer.

Clean glass ONLY when the unit has cooled down.
6.2

GASKET

We recommend replacing the gasket that seals the door once a year, in order to maintain a good control of the
combustion for maximum efficiency and security. To replace your door gasket, remove the old gasket and adhesive.
Clean the surface thoroughly, apply a high-temp adhesive/silicone (650
new gasket onto the door. Wait for at least 4 hours before lighting your furnace.
o
F) sold for that particular use, and put the
41
www.psg-