Brother DCP-9055CDN Service Manual page 429

■ Switching of timing to execute Auto Registration
<Function>
Relative displacement between Cyan, Magenta, Yellow, and Black is detected using the
registration mark sensor, and the Auto Registration is executed at the timing when the
displacement value exceeds the stipulated threshold value.
This is a function to switch the threshold value which is used as the timing to execute Auto
Registration.
The threshold value can be switched in three phases between High, Mid, and Low.
LCD
Regi Freq=Mid
Regi Freq=High
Regi Freq=Low
An asterisk "*" appears beside the current setting.
Note:
It can be set regardless of the Auto Registration switching function in the function
menu. Even if this function is switched, it does not affect the timing to execute Auto
Registration in the function menu.
<Operating procedure>
(1) Press the 4 and 5 buttons in this order in the initial state of the maintenance mode.
The "USBNo." will appear on the LCD.
(2) Press the or
button.
(3) Select "Regi Freq = Mid", "Regi Freq = High", or "Regi Freq = Low" by pressing
the or button, and press the OK or Start/Black button.
(4) "Accepted" is displayed on the LCD, and the product goes back to the initial state of the
maintenance mode.
The frequency to execute Auto Registration is middle. (default)
The frequency to execute Auto Registration is high.
The frequency to execute Auto Registration is low.
button to display "Regi Freq" and then press the OK or Start/Black
5-30
Description
Confidential